| Author |
Message |
Chuck MC8 (68.158.34.204)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, August 31, 2003 - 5:35 pm: | |
We'll I'm finally getting around to installing my new fuel guage in my 1977 MC8. The bus wasn't equipped with one from the factory.
My guage is MCI part #456E, 24v neg gnd. below that on the ID sticker on the guage reads the numbers 76-13-12.
My question is: there are three lugs on the back of the guage. one is labeled "S", another labeled "G" and the third "I".
My manual dosent give a schematic for the guage wiring.
Anyone know the correct wiring for the guage?
Thanks Chuck |
Frank Allen (152.163.252.163)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, August 31, 2003 - 6:55 pm: | |
S is the sender, G is the Ground and i has to be the hot wire
Frank allen
4106 |
two dogs (67.30.23.77)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, September 01, 2003 - 9:33 am: | |
the "I" is ignition..please don't get things mixed up & send 24 volts to the fuel tank...this wire hooks up to your ignition switch ,hot only with the switch turned on... |
Frank Allen (152.163.252.163)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, September 01, 2003 - 12:24 pm: | |
Im sorry , what was i thinking?? im sorry for that incorrect answer
Frank allen
4106 |
Brian James Houk (Brianmci96a3) (65.41.249.35)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, September 11, 2003 - 12:58 am: | |
two dogs has the right of it, I for ignition switch
G for ground and S for sender, and Frank it wouldn't have been so bad, a hot wire to the I terminal on the gauge would not send 24V to the sender in the tank, the gauge would simply read at all times!
Brian |