| Author |
Message |
Austin Davis (Zimtok)
Registered Member
Username: Zimtok
Post Number: 93
Registered: 9-2006
Posted From: 216.37.73.226
Rating: N/A
Votes: 0 (Vote!) | | Posted on Tuesday, February 20, 2007 - 8:28 am: | |
I replaced the injector seals on Sunday. After doing a few I decided to video the process. I had to edit out a lot of dead time to fit it on YouTube (100meg) so you'll see the video jump.
Here is the link:
http://www.youtube.com/watch?v=BqaxhG7SPmQ
The seals I removed were very hard and some were cracked.
What is not shown in this video is me cleaning the carbon build-up off of the injector tip before I disassembled it. And I also checked every fuel line for damage.
I did a pressure test after all were done and there is no leaks. I will keep an eye on the oil for a while to make sure. |
Bob greenwood (Bob_greenwood)
Registered Member
Username: Bob_greenwood
Post Number: 708
Registered: 7-2006
Posted From: 64.136.49.228
Rating: N/A
Votes: 0 (Vote!) | | Posted on Tuesday, February 20, 2007 - 8:51 am: | |
atta boy Austn |
Ednj (Ednj)
Registered Member
Username: Ednj
Post Number: 138
Registered: 3-2003
Posted From: 67.85.229.237
Rating: N/A
Votes: 0 (Vote!) | | Posted on Tuesday, February 20, 2007 - 12:50 pm: | |
Austin,
Nice job thanks for sharing |
james dean boggs (Jd_boggs)
Registered Member
Username: Jd_boggs
Post Number: 108
Registered: 11-2004
Posted From: 75.80.240.25
Rating: N/A
Votes: 0 (Vote!) | | Posted on Friday, February 23, 2007 - 1:07 am: | |
Nice job on the injector replacement. Wish I had more videos on how to: brake shoe replacement, air shocks replace, fuel pump priming etc. |
joe padberg (Joemc7ab)
Registered Member
Username: Joemc7ab
Post Number: 86
Registered: 6-2004
Posted From: 66.38.159.33
Rating: N/A
Votes: 0 (Vote!) | | Posted on Friday, February 23, 2007 - 2:15 am: | |
Heard the click of the torque wrench and the dog barking, but no grunt when reassembling the injector. I enjoyed it. Joe.
H |
Austin Davis (Zimtok)
Registered Member
Username: Zimtok
Post Number: 95
Registered: 9-2006
Posted From: 216.37.73.226
Rating: N/A
Votes: 0 (Vote!) | | Posted on Friday, February 23, 2007 - 11:56 am: | |
In these days of technology it is easy to set up a video camera and document procedures like this.
I hope a few others will do similar videos and post them.
I plan on doing more.
I was glad to hear the click of the torque wrench on the video. The mic is pretty good on this camera.
. |